Dji S800 User Manual download pdf (Page 14)

3 Transmitter Setting

Select a 2-position switch (default setting is OK) of

Transmitter as the control input of the landing gear, and

then make sure the corresponding port of receiver is

connected to the [IN] port on control board.

Fig. 1

Fig. 2

4 Usage

The landing gear can be used by following the steps below after assembly & connection.

1. Make sure the transmitter & receiver batteries are fully charged.

2. Toggle the switch to the [Lower] position, and then turn on the transmitter.

3. Make sure the [R], [L] and [IN] connections are correct and firmly connected.

4. Make sure the Landing Gear is at the [Lower] position, and then power on the system. If the green LED is

solid on, then this is a normal start. If the LED flashes GREEN slowly, please re-calibrate the system

according to the procedure of Travel Calibration.

5. Make sure to toggle the switch to the [Retracted] position ONLY AFTER you takeoff the aircraft.

6. When the aircraft is landing, please toggle the switch to the [Lower] position for a safe landing.

Retracted：Toggle the switch to

this position to retract the

landing gear (Fig.1)

Lower：Toggle the switch to this

position to lower the landing

gear (Fig. 2)

Tips:

(1) If the switch of Transmitter has FailSafe function,

set the FailSafe value to the [Lower] position, so

that the landing gear will be in [Lower] status when

the receiver enters FailSafe mode, to land the

aircraft safely.

(2) To avoid false switch triggering, you can use the

slide lever or other trim as the landing gear’s

control switch.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

No comments

Dji S800 User Manual Page 14