Dji Z15 User Manual download pdf (Page 17)

Video Signal Transmission

A wireless video transmission module is necessary for video signal accessing remotely.

Wireless Video

Transmission Module

　Air End

Power(Red:1A@12V)

Video Signal(Yellow:AV)

GND(Black:　　)

Power

Video Signal

GND

Gimbal Video Power Cable

Video Signal Port

Step1: Respectively solder the Power/Video Signal/GND cables to wireless video transmission module

(Air End).

Step2: Plug the gimbal video power cable head into the GCU Video Signal Port.

Notices:

 Make sure to connect Wireless Video Transmission Unit to GCU first, then power on.

 Set HDMI Resolution as 1080i for Z15-N; set the REC MODE as AVCHD (1080i) using Z15-G;

otherwise the wireless video transmission module will work abnormally.

 The standard gimbal video power cable is recommended.

 Make sure you solder the gimbal video power cable to the wireless video transmission unit correctly,

to avoid the 12V power burn the gimbal or your own device. And ensure the cables are insulated, to

prevent from short circuit.

Power Cable(1A @12V)

Video Signal Cable(AV)

GND Cable

 Ensure the 12V power is safe for you own device when using other power cable.

 Make sure the wireless video transmission module current consumption does not exceed 1A, to

prevent GCU from damage.

Tips:

 Following diagram shows how video signal transit when gimbal working.

 If video signal access fails, please check each step.

Camera

HDMI

Gimbal

HDMI-AV module

HDMI signal

GCU

AV signal

Wireless video

transmission

module

Air end

HDMI-AV cable

8-Pins cable

Gimbal Video

Power Cable

Wireless video

transmission

module

Ground end

Wireless signal

Monitor

AV input

5.8G/2.4G/1.2G

Self-prepared by user

AV signal

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Comments to this Manuals

No comments

Dji Z15 User Manual Page 17

Comments to this Manuals

Related products and manuals for Hardware Dji Z15