Dji PHANTOM 2 VISION+ User Manual download pdf (Page 31)

11 Flight

11.1 Flying Environment Requirements

(1)

(2)

(3)

(4)

(5)

(6)

(7)

Before your first flight, please allow yourself some flight training (Using a flight simulator to

practice flying, getting instruction from an experienced person, etc.).

DO NOT fly in bad weather, such as rain or wind (more than moderate breeze) or fog.

The flying field should be open and void of tall buildings or other obstacles; the steel structure

within buildings may interfere with the compass.

Keep the aircraft away from obstacles, crowds, power lines, trees, lakes and rivers etc.

Try to avoid interference between the remote controller and other wireless equipment. (No base

stations or cell towers around)

The flight control system will not work properly at the South Pole or North Pole.

All parts must be kept out of the reach of children to avoid CHOKING HAZARDS; if a child has

accidentally swallowed any part, you should seek immediate medical assistance.

11.2 Starting the Motors

A Combination Stick Command (CSC) is used to start the motors instead of simply pushing the throttle stick up.

This is a safety precaution to prevent the motors from accidentally spinning up. Push both sticks to their bottom

corners as indicated in the diagram below to start the motors. Once the motors have spun up, release both sticks

simultaneously. The same combination stick command (CSC) is used to stop the motors.

11.3 Takeoff/Landing Procedures

Start by placing the PHANTON 2 VISION on the ground with the battery level indicator facing you.

Power on the remote controller.

Power on the range extender.

Switch the camera to the “WIFI ON” position.

Power on the aircraft by turning on the intelligent battery, refer to <Battery Usage> for details.

Connect the mobile device to the PHANTOM 2 VISION and then run the DJI VISION App to enter the

camera preview page.

Wait until the LED flight indicator starts to slowly blink green/yellow. This means the aircraft is initializing

and entering the “Ready to Fly”/“Ready to Fly (non-GPS).” state. Then proceed to execute the CSC

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 67 68

No comments

Dji PHANTOM 2 VISION+ User Manual Page 31