Dji PHANTOM 2 VISION+ User Manual download pdf (Page 9)

(1)

(2)

(3)

(4)

If the low voltage warning alert sounds (refer to the <Remote Controller Power Indicator Status

Information>), please replace batteries as soon as possible.

Using the incorrect type of battery may prevent a risk of damage.

Remove the batteries after use and dispose of them safely.

For long term storage, be sure to remove the batteries from the remote controller.

3.3 Remote Controller Power Indicator Status Information

Power indicator

Sound

Remote Controller State

None

Functioning normally.

None

Establishing a link between the remote controller and the receiver.

B-B-B……

Low voltage (at 3.9V-4.5V), should replace the batteries immediately.

BBBB

Low voltage (lower than 3.9V). The remote controller will automatically

power off. Batteries should be replaced immediately.

B-B-B……

The remote controller will give a visual indication of an alarm after 15

minutes of non-operation. The alarm status will disappear once you start

operation of the remote controller.

The remote controller will blink the LED and sound an alert when the voltage drops below 3.9V and

automatically power off after 3 seconds. This process will repeat even if you power cycle the remote

controller. If this low voltage warning occurs during flight, the remote controller will automatically

power off causing the aircraft to enter Failsafe mode which cannot be interrupted (refer to <Failsafe

Function> section for details). It is strongly recommended to replace batteries if the 3.9V-4.5V low

voltage warning occurs.

3.4 Antenna Orientation

Try to keep the antenna pointing skyward, perpendicular to the ground, in order to achieve the maximum

communication range during flight.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

No comments

Dji PHANTOM 2 VISION+ User Manual Page 9