Dji Z15-5D III (HD) User Manual download pdf (Page 23)

Zenmuse Z15-5D III

(

)

User Manual

1. Prepare one 14-channel TX/RC receiver for the aircraft and gimbal control. Above is an example of the

wiring conguration.

2. Setup the Aileron, Elevator, Throttle, and Rudder channels on your TX for aircraft roll, elevator, throttle, and

rudder control. Also, connect the TX’s AUX2 for aircraft control modes (Please refer to your Flight Control

System’s user manual).

3. Choose three 3-position switches to use for the gimbal ROLL, TILT, and PAN rotation control. The center

position of each switch is 0 velocity, and the end point positions are maximum velocity.

4. Choose one 3-position switch/channel as the gimbal’s Working Modes switch (MODE).

5. Choose one 2-position switch/channel as the camera shutter control switch (SHUT).

6. Connect the receiver to the GCU and Flight Control System Main Controller correctly.

2-Pilot Solution

S-Bus

PPM

GCUGCU

ROLL

TILT

PAN

MODE

SHUT

AUX1

AUX2

AUX3

RC Receiver A

Gimbal Control Unit（GCU）

Transmitter A

Gimbal Control

Flight Controller

RC Receiver B

RC Receiver

（JR）

8 Channels

RC Receiver

（JR）

8 Channels

S-Bus

Transmitter B

DJI WooKong-M Flight Controller

RC Receiver

(Futaba/Hitec)

8 Channels

RC Receiver

(Futaba/Hitec)

8 Channels

S-BUS Receiver

(Futaba)

S-BUS Receiver

(Futaba)

PPM Receiver

2-Position Switch

3-Position Switch

2-Position Switch

3-Position Switch

2-Position Switch

-HD

14V

52V

Two transmitters and two receivers are required.

Transmitter A and receiver A are used to control the gimbal.

Transmitter B and receiver B are used to control the aircraft.

Make the connections as shown in the diagram below:

Appendix

Please refer to the GCU Wiring section for more details.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Dji Z15-5D III (HD) User Manual Page 23

Comments to this Manuals

Related products and manuals for Hardware Dji Z15-5D III (HD)