Dji Z15-5D III (HD) User Manual download pdf (Page 25)

Zenmuse Z15-5D III

(

HD

)

User Manual

©

2014 DJI. All Rights Reserved.

25

Troubleshooting

NO. The Problem The Cause What to Do

1

The gimbal keeps drifting

after initialization.

(1) The TX trims are too high.

(2) The GCU and Flight

Control System have

been disconnected.

(3) The gimbal direction is

not pointing in the same

direction as the aircraft’s

nose.

(1) Adjust the TX trims.

(2) Connect the GCU and Flight

Control System.

(3) Ensure the gimbal direction is

pointing in the same direction

as the aircraft’s nose.

2

The gimbal is in an

incorrect position after

initializing.

Abnormal calibration after

manufacturing.

Please contact your local dealer

or DJI customer service.

3

Cannot distinguish the

gimbal’s direction when in

use.

BVR (Beyond Visibility

Range) ight.

Switch to FPV Mode rst, then

to another Working Mode as

needed.

4

The gimbal LED is blinking

red.

(1) There is a disconnected

cable between the gimbal

and camera.

(2) The camera is off.

(3) Camera setup failure.

(1) Make sure all cables are

securely connected.

(2) Power on the camera.

(3) Set the HDMI resolution to

1080i.

5

The gimbal’s green or

yellow LED is continuously

on, but no video is

displayed.

(1) The HDMI-HD/AV

transmission module is

disconnected from the

camera.

(2) The camera is powered off.

(3) In HD mode, the DJI

Lightbridge App video

source has been set to

“HDMI/AV”.

(1) Check HDMI-HD/AV

transmission module

connection.

(2) Power on the camera.

(3) Change the DJI Lightbridge

App video source to "HD

Gimbal".

Appendix

1 2 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments