Dji Phantom 2 Vision + User Manual download pdf (Page 49)

Page 49

Camera update

Using the DJI Phantom 2 Vision Assistant, check the current firmware version of your FC200 Camera.

Then, check if there’s a new firmware update for the Phantom 2 Vision FC200 Camera on DJI web site.

If a firmware update is needed, then follow the instructions below to update your firmware.

a) Download the latest camera firmware and unzip it.

b) Get a clean Micro-SD card (less than or equals to 32GB), and copy the “firmware.bin” file to the root folder of the

SD card.

c) Make sure the Phantom is turned off, and insert the Micro-SD card into the camera before turning it on.

d) Turn on the Phantom. Note: the P2V+ camera does not have an on/off switch.

e) The firmware update will begin automatically. A yellow flashing LED on the camera indicates that the camera is

updating.

f) When the yellow flashing disappears, the firmware has been updated. After a successful update, the “firmware.bin”

file name will change to “firmware.bin.bak”. This file on the card can now be deleted.

Special Notes:

a) During the update, do not turn off the Phantom or take out the SD card. This may prevent your camera from

switching on and will need a factory reset.

b) A fast red flashing LED on the camera after the update means the update has failed. Please try again.

c) You need to use the latest DJI Vision App.

1 2 ... 44 45 46 47 48 49

No comments

Dji Phantom 2 Vision + User Manual Page 49