Dji Phantom 2 Vision + User Manual download pdf (Page 33)

Ready to Fly ---- Automatic go home and land

The flight control system will automatically control the aircraft to fly back to the home point and land.

Home Point

When the aircraft is initializing the Ready to Fly status, the aircraft will record the current GPS coordinates as the

home point. It is recommended to lift off only after Ready to Fly status is confirmed for the safety of being able to

fly back to home point successfully in case the Failsafe mode is initiated.

Dynamic Home Point

The Home point will be reset to position of the mobile device at specific time intervals.

(1) Enable dynamic home point in DJI Vision app or Phantom 2 Assistant.

(2) Dynamic home point is only available to the GPS-enabled mobile device. Turn on GPS and data service to obtain

higher accuracy of the mobile device position.

point is useful in situations when you are in motion and require a Home point that is different

from the takeoff point.

Go Home Procedures

1 Record Home Point.

2 Flying.

3 Remote controller signal lost.

5 Fly back to home point.4 Signal lost lasts 3s, begin to go home.

6 Landing after hovering 15s.

LED Flight Indicator



LED Flight Indicator

LED Flight Indicator LED Flight Indicator LED Flight Indicator

Height over home point<=20m

Height over home point>20m

20m

Elevate to 20m

(1) In a Failsafe situation, if less than 6 GPS satellites are found for more than 20 seconds, the aircraft will

descend automatically.

(2) When the aircraft is landing automatically, users can control the aircraft’s position and altitude if the

remote controller signal is recovered.

(3) Aircraft cannot navigate around vertical obstacles on its return home course during Failsafe. However,

you can set return home altitude value in Phantom Assistant to avoid hitting vertical obstacles

through DJI Phantom Assistant.

In Phantom 2 Vision mode, users can set a new home point manually when the aircraft is in “Ready to fly”

status as long as a home point has been recorded automatically. Quickly flipping the S2 switch of the

remote controller from upper most to lower most positions 5 times or more will reset the current aircraft

position as a new home point of PHANTOM 2 VISION. When successfully reset, you will see a series of

rapid green blinks on the LED Flight Indicator. The definition of “home point” is: i) The home point is the

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 70 71

No comments

Dji Phantom 2 Vision + User Manual Page 33