Dji Phantom 2 Vision + User Manual download pdf (Page 63)

Language swap

View configurations

Connection indicator

Communication

indicator

RC, Gain

Gimbal, Battery

IMU calibration

Firmware upgrade

Account, software

version

*This image is for reference

only. Please refer to the

actual user interface.

Function switch between PHANTOM

2 VISION and NAZA-M

(1) Users should not enable the Naza-M function before finishing the “Advanced Flight Maneuvers”

procedure, in accordance with the "Phantom Pilot Training Guide”. If the Naza-M function is

enabled, users can switch the control mode to either the ATTI. Mode, GPS Mode or Manual Mode,

and access the advanced settings (e.g. IOC). In addition, the LED located on the rear frame arms

will display the flight status according to the Naza-M's indicator, instead of the Phantom 2 Vision's

indicator. Do not enable the Naza-M function unless you are an experienced user or guided by a

professional.

(2)You can change to the Phantom 2 Vision function by tapping the same button if the Naza-M

function is enabled. This operation will disable the Naza-M function and enable the Phantom 2

Vision function.

All parameters will be

returned to factory settings.

13.3 Firmware Upgrade of the PHANTOM 2 VISION

Please refer to the PHANTOM 2 VISION Assistant to install driver and PHANTOM RC Assistant, and then follow

the procedures below to upgrade the software and firmware; otherwise the PHANTOM 2 VISION might not work

properly.

An internet connection is required to upgrade the PHANTOM 2 VISION’s firmware.

Click the [Upgrade] icon to check the current firmware version and whether the installed firmware is the

latest version. If not, click the relative links to upgrade.

Be sure to wait until the Assistant shows “finished”. Click OK and power cycle the PHANTOM 2 VISION

after 5 seconds. Once completed, the firmware is up to date.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70 71

No comments

Dji Phantom 2 Vision + User Manual Page 63